mp:lathe_matrix
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| mp:lathe_matrix [2021/10/19 16:35] – russell | mp:lathe_matrix [2023/01/19 15:52] (current) – allan | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| //Any supplementary info on this post section goes here// | //Any supplementary info on this post section goes here// | ||
| - | The toggles in this section should be used first //instead of changing any string selectors (see below example) for output in the post.// Ex: don't ever change the following section in a lathe post, as these controls are in the sections below: | + | The toggles in this section should be used first //instead of changing any string selectors (see below example) for output in the post.//\\ |
| + | Ex: don't ever change the following section in a lathe post, as these controls are in the sections below: | ||
| < | < | ||
| Line 14: | Line 15: | ||
| </ | </ | ||
| - | As these settings are specific to spindle/ | + | All below settings are specific to spindle/ |
| Note, all changes are made in the final sections, the initial sections are just descriptions and notes. | Note, all changes are made in the final sections, the initial sections are just descriptions and notes. | ||
| Line 46: | Line 47: | ||
| </ | </ | ||
| - | The below section dictates the G2/G3 and G41/G42 directions on each plane. These are linked so they change together when toggled. It is not typical for G2/G3 and G41/G42 to be unlinked in direction. Switching C/D/E for any toolpath type switches the compensation for that toolpath type. ex: setting to 1 for "Right Face cut" will flip the G2/G3 and G41/G42 directions for only "Right Face cut" toolpaths. | + | The below section dictates the G2/G3 and G41/G42 directions on each plane. These are linked so they change together when toggled. It is not typical for G2/G3 and G41/G42 to be unlinked in direction. Switching C/D/E for any toolpath type switches the compensation for that toolpath type. ex: setting to 1 for "Right Face cut" will flip the G2/G3 and G41/G42 directions for only "Right Face cut" toolpaths. See [[mp: |
| < | < | ||
mp/lathe_matrix.1634661307.txt.gz · Last modified: 2021/10/19 16:35 by russell
Page Tools
