Differences

This shows you the differences between two versions of the page.

--- mp:lathe_matrix [2021/10/19 16:35] – russell
+++ mp:lathe_matrix [2023/01/19 15:52] (current) – allan
@@ Line 15: / Line 15: @@
 </code>
-As these settings are specific to spindle/turret/toolpath type changing here prevents a change affecting unwanted toolpath types and spindles.
+All below settings are specific to spindle/turret/toolpath type. Changing these prevents a change affecting unwanted toolpath types and spindles.
 Note, all changes are made in the final sections, the initial sections are just descriptions and notes.
@@ Line 47: / Line 47: @@
 </code>
-The below section dictates the G2/G3 and G41/G42 directions on each plane. These are linked so they change together when toggled. It is not typical for G2/G3 and G41/G42 to be unlinked in direction. Switching C/D/E for any toolpath type switches the compensation for that toolpath type. ex: setting to 1 for "Right Face cut" will flip the G2/G3 and G41/G42 directions for only "Right Face cut" toolpaths.
+The below section dictates the G2/G3 and G41/G42 directions on each plane. These are linked so they change together when toggled. It is not typical for G2/G3 and G41/G42 to be unlinked in direction. Switching C/D/E for any toolpath type switches the compensation for that toolpath type. ex: setting to 1 for "Right Face cut" will flip the G2/G3 and G41/G42 directions for only "Right Face cut" toolpaths. See [[mp:planes| the convention for arcs/planes]] for reference.
 <code>

Post Wiki