mp:lathe_matrix
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| mp:lathe_matrix [2021/10/19 16:37] – russell | mp:lathe_matrix [2023/01/19 15:52] (current) – allan | ||
|---|---|---|---|
| Line 47: | Line 47: | ||
| </ | </ | ||
| - | The below section dictates the G2/G3 and G41/G42 directions on each plane. These are linked so they change together when toggled. It is not typical for G2/G3 and G41/G42 to be unlinked in direction. Switching C/D/E for any toolpath type switches the compensation for that toolpath type. ex: setting to 1 for "Right Face cut" will flip the G2/G3 and G41/G42 directions for only "Right Face cut" toolpaths. | + | The below section dictates the G2/G3 and G41/G42 directions on each plane. These are linked so they change together when toggled. It is not typical for G2/G3 and G41/G42 to be unlinked in direction. Switching C/D/E for any toolpath type switches the compensation for that toolpath type. ex: setting to 1 for "Right Face cut" will flip the G2/G3 and G41/G42 directions for only "Right Face cut" toolpaths. See [[mp: |
| < | < | ||
mp/lathe_matrix.1634661452.txt.gz · Last modified: 2021/10/19 16:37 by russell
Page Tools
