Differences

This shows you the differences between two versions of the page.

--- mp:post_caputured_errors [2021/07/21 21:00] – created allan
+++ mp:post_caputured_errors [2024/04/25 19:13] (current) – [PY] russell
@@ Line 1: / Line 1: @@
+===== Errors in MP log file =====
 ====== PY ======
->ERROR - TOOL LENGTH COMPENSATION NOT ENABLED DURING OPERATION MOTION\\Safety check to make sure tool length comp is on for motion.  Check to make sure 'tlenflg<>0' by looking at conditions in 'ptlen', eg. 'axcomb' needs to be correct in Mastercam.
+===== Tool Length Comp =====
+>ERROR - TOOL LENGTH COMPENSATION NOT ENABLED DURING OPERATION MOTION
+Safety check to make sure tool length comp is on for tool.  Check to make sure ''tlenflg <> 0'' by looking at conditions in ''ptlen'', eg. ''axcomb'' needs to be correct in Mastercam for mill-turn.
+===== ALL POSTS =====
+===== STARTBIN ENDBIN error =====
+>ERROR  -  The [STARTBIN] and [ENDBIN] tags in the post are not matched single level sets. Please correct the post file.\\
+probable answer:
+I was not able to duplicate this error when I installed the post files normally. I was able to duplicate this exact error when the PSB file was not in the folder with the PST file.
+Can you make sure that the PST/PSB/DAT files are all together in the post folder and that none of them are renamed?
+This is the only cause I can think of. If you continue to be stuck then if you are able to send a zip to go there might be more we can determine.

Post Wiki