===== Errors in MP log file =====


====== PY ======
===== Tool Length Comp =====

>ERROR - TOOL LENGTH COMPENSATION NOT ENABLED DURING OPERATION MOTION
Safety check to make sure tool length comp is on for tool.  Check to make sure ''tlenflg <> 0'' by looking at conditions in ''ptlen'', eg. ''axcomb'' needs to be correct in Mastercam for mill-turn.

===== ALL POSTS =====


===== STARTBIN ENDBIN error =====

>ERROR  -  The [STARTBIN] and [ENDBIN] tags in the post are not matched single level sets. Please correct the post file.\\

probable answer:

I was not able to duplicate this error when I installed the post files normally. I was able to duplicate this exact error when the PSB file was not in the folder with the PST file.

Can you make sure that the PST/PSB/DAT files are all together in the post folder and that none of them are renamed?

This is the only cause I can think of. If you continue to be stuck then if you are able to send a zip to go there might be more we can determine.